User's Manual

User Manual
http://www.pepwave.com
26
Copyright © 2015 Pepwave
To add a community for either SNMPv1 or SNMPv2c, click the Add SNMP Community
button in the Community Name table, which displays the following screen:
SNMP Community Settings
Community Name
Enter a name for the SNMP community.
IP Address/IP
Mask
These settings specify a subnet from which access to the SNMP server is allowed.
Enter the subnet address here (e.g., 192.168.1.0) and select the appropriate subnet
mask.
Access Mode
Select Read Only or Read and Write as the SNMP community access mode.
Status
Use these controls to enable or disable SNMP community access.
To define a user name for SNMPv3, click Add SNMP User in the SNMPv3 User Name
table, which displays the following screen:
SNMPv3 User Settings
SNMPv3 User
Name
Enter a user name to be used in SNMPv3.
Authentication
Protocol
Select one of the following valid authentication protocols:
 NONE
 HMAC-MD5
 HMAC-SHA
When HMAC-MD5 or HMAC-SHA is selected, an entry field will appear for the
password.
Authentication
Password
Enter a password to use with the selected authentication protocol.