User's Manual

User Manual

http://www.pepwave.com

7.2.2 Settings

Basic access point operation settings, such as the protocol and channels used, as well

as scanning interval and other advanced settings, can be defined and managed in this

section.

AP Settings

Protocol

Choose 802.11ng or 802.11na as your access point’s Wi-Fi protocol.

The AP One AC mini provides the 802.11ng protocol for the 2.4 GHz band and the

802.11ac protocol for the 5GHz band, as shown below.

Operating

Country

This drop-down menu specifies the national / regional regulations the AP should follow.

 If a North American region is selected, RF channels 1 to 11 will be available and the

maximum transmission power will be 26 dBm (400 mW).

 If European region is selected, RF channels 1 to 13 will be available. The maximum

transmission power will be 20 dBm (100 mW).

NOTE: Users are required to choose an option suitable to local laws and regulations.

Per FCC regulation, the country selection is not available on all models marketed in the

US. All US models are fixed to US channels only.

Channel Bonding

There are three options: 20 MHz, 40 MHz, and 20/40 MHz. With this feature enabled,

the Wi-Fi system can use two channels at once. Using two channels improves the

performance of the Wi-Fi connection.

The AP One AC mini offers channel bonding options for the 2.4GHz and 5GHz bands,

as shown below. In addition to 20 MHz, 40 MHz, and 20/40 MHz, the 5Ghz band offers

80Mhz, which is the default setting.