User's Manual

User Manual

http://www.pepwave.com

Advanced

Management

VLAN ID

This field specifies the VLAN ID to tag to management traffic, such as AP-to-AP

controller communication traffic. The value is 0 by default, meaning that no VLAN tagging

will be applied. NOTE: change this value with caution as alterations may result in loss of

connection to the AP controller.

Spanning Tree

Protocol

Checking this box enables spanning tree protocol, used to prevent loops in bridged

Ethernet LANs

Scheduled

Reboot

When this box is checked, your access point can be scheduled to reboot automatically

on a recurring basis, as indicated by the values under the Schedule, Day, and Time

headings.

Ethernet

Speed/Duplex

Select a speed and duplex setting for sending and receiving. When selecting a speed

manually, you can also control whether the access point’s speed will be advertised on

the network by checking or unchecking the Advertise Speed box. When Auto is

selected, your access point will automatically negotiate speeds.

AP Mode

Your access point can act as a bridge or as a router, depending on your selection here.

When Router is selected, you can additionally select whether the access point will

function in NAT or IP Forwarding mode.