User Manual

ENGLISH

7.     

Parts Required:

1 x Main Barrel / Hopper Assembly

(#9)

Installation:

• Take the Main Barrel / Hopper Assembly out with foam on its sides.

• Use the scissors to cut the cable tie which is under the Main Barrel / Hopper

Assembly to release the regulator and Lighting rod.

NOTE: Do not use knife to cut the cable tie because knife may damage

the regulator hose which may cause gas leaking.

8.    /     

Parts Required:

1 x Main Barrel / Hopper Assembly

(#9)

Installation:

• Use a second person to lift the Main Barrel / Hopper Assembly then seat it

to the pre-assembled cart.

NOTE: The regulator needs to be put inside the cart and the lighting rod

keep outside of the cart, the hose of the regulator needs to go through

the hole in the Front-Right Leg.

9.    /     

Parts Required:

1 x Main Barrel / Hopper Assembly

(#9)

16 x Screw

(#A)

16 x Locking Washer

(#D)

16 x Washer

(#C)

Installation:

• Mount the Main Barrel / Hopper Assembly to the pre-assembled cart.

Use: 16 pcs M6 x 15 screws, 16 pcs washer, and 16 pcs locking washer.

10.    

Parts Required:

1 x Regulator Hose Retainer

(#F)

1 x Screw

(#B)

Installation:

• To avoid the lighting rod from falling on the ground, put the end of the

lighting rod on the step screw as shown in illustration.

• Use Regulator Hose Retainer to fix the regulator hose then use M5x12 screw

to mount the Regulator Hose Retainer to Front-Right Leg.

  