User Manual

ENGLISH

27.    

Parts Required:

1 x Grease Tray

(#12)

Installation:

• Mount the Grease Tray to the Main Barrel/Hopper Assembly.

28.    

Parts Required:

1 x Grease Bucket

(#26)

Installation:

• Mount the Grease Bucket to the Main Barrel/Hopper Assembly.

• The unit is now completely assembled.

29.     

NOTE: Before plugging your Pit Boss® into any electrical outlet, ensure

the temperature dial is in the OFF position.

•

 

This appliance requires 120 volt, 60hz, 300W, 5 amp service. It must be a

3-prong grounded plug. Ensure grounded end is not broken off before use.

The control uses a 5 amp, 120 volt, fast-blow fuse to protect the board from

the igniter.

•

 

This appliance will work on most GFCI outlets, with a recommended size

of 15 amp service. If your GFCI outlet is highly sensitive to power surges,

it will likely trip during the start-up phase of operation. During the start-

up phase, the igniter draws 200-700 watts of electricity which can be too

much power for a GFCI outlet to handle. Each time it trips, it increases in

sensitivity. If the GFCI keeps tripping, replace the outlet or change to a non-

GFCI outlet.

•

  

Disconnect the igniter and the light from the main wiring harness. Use the

manual start-up procedure. A Pit Boss® unit can operate using a 12 volt, 100

watt inverter plugged into your automobile outlet. To use the automatic

igniter, it is recommended to use a minimum of a 1000 watt inverter.

IMPORTANT: Disconnect unit from power source when not in use.

 ,

5 