User Manual
ENGLISH
17
1
2
3
The grill is set and tested with liquid propane gas only. The regulator supplied is set for 27.94 cm (11 inch) water column (WC) and
is for use with LP gas only. The factory-supplied regulator and hose must be used with a 9 kg (20 lbs) LP gas tank. Contact your
gas supplier for a special regulator for bulk gas that fuels other appliances.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident there is excessive
abrasion or wear, or the hose is cut, the hose must be replaced prior to the appliance being used.
1. From the side of the cart, place foot ring of 9 kg (20 lbs) tank onto the gas tank support bracket Fig 1. Make sure the
tank valve is in OFF position. Put tank handle to LP Gas Cylinder Wire Retainer and secure tightly Fig 2. Ensure the tank is
completely upright, as it is unsafe to operate the grill if the gas tank is not installed properly.
2. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
3. Remove the protective caps from the regulator valve opening and the top of the gas cylinder. Save the caps.
4. Insert the gas cylinder valve into the threaded opening of the regulator valve. Turn the cylinder clockwise until firm. Hand-
tighten only.
5. Gas cylinder is now installed.