User's Manual

ManualsBrandsPitco Frialator ManualsDeep FryersB2005302

L20-314 Rev 0 (9/7/07)

English

This control was developed by Pitco to replace bulb and capillary thermostats in fryer

applications. It utilizes the latest in microprocessor technology and allows a host of features

not practical with a simple capillary t-stat. Features include a selectable start up melt cycle,

drain valve interlock, faulty probe detection, and a boil out mode.

This manual details the operation and adjustment of the Solid State Temperature Control.

IMPORTANT INFORMATION FOR FUTURE REFERENCE

Record the following information from the appliance ID plate

and retain this manual for the life of the equipment:

Model #: __________________________

Serial #: __________________________

Date Purchased: ___________________

Operations Manual

Covering Pitco #

B2005301 SSTC Primary Control for GAS appliances

B2005302 SSTC Backup Control for GAS appliances

B2005303 SSTC Primary Control for Electric appliances

B2005304 SSTC Backup Control for Electric appliances

B2005305 SSTC Backup Control for SE147 Electric appliances

B2005401 SSTC Primary Control for Flat Bottom GAS appliances

Solid State Temperature Control

PRIMARY BACKUP FLAT BOTTOM

Summary of content (4 pages)

PAGE 1
English IMPORTANT INFORMATION FOR FUTURE REFERENCE Record the following information from the appliance ID plate and retain this manual for the life of the equipment: Model #: __________________________ Serial #: __________________________ Date Purchased: ___________________ Operations Manual Covering Pitco # B2005301 SSTC Primary Control for GAS appliances B2005302 SSTC Backup Control for GAS appliances B2005303 SSTC Primary Control for Electric appliances B2005304 SSTC Backup Control for Electric applia
PAGE 2
Solid State Temperature Control (SSTC) 1 Switch and Indicator Locations and Function: PRIMARY On / Off switch: Turns the control on or off. The power indicator will be illuminated when the switch is in the on position. Primary / Backup select switch: In appliances with primary AND a backup control, this switch selects the control that will manage temperature in the appliance. When the switch is in the single dot position, power is diverted to the primary control, typically an I12 cooking computer.
PAGE 3
Solid State Temperature Control (SSTC) 2 2.1 Operation: Turn the appliance ON: Place the melt switch in the desired position, typically Melt . No melt may also be selected only if vat is filled with liquid cooking oil. Turn the control ON by pressing the rocker switch to the “1” position. The green power indicator will illuminate. 2.2 To turn the appliance OFF: Turn the control OFF by pressing the rocker switch to the “O” position. The green power indicator will go out. 2.
PAGE 4
Solid State Temperature Control (SSTC) 3 3.1 Fault Detection High Limit Trip or “Heat Failure”: This control monitors the appliance response to heat demand signals. Under normal conditions the heat feed back indicator follows the heat demand indicator. When the appliance fails to respond, the heat feed back indicator will remain off. Typical causes are: High Limit device is tripped and needs to be reset. On gas appliances, a substandard pilot flame, or ignition module problem may be indicated.