User guide

Heritage I12 Computer, Single Vat (PP11370) and Dual Vat (PP11372)
Quick Reference Card
L20-320 Rev 0 10/07
1 22
0 0
1
HERITAGE I12 COMPUTER QUICK PROGRAMMING CARD
TURN ON and OFF
To Turn the Appliance ON : (See Note 1)
Press Rocker Switch to on. Display will
show:[HEATING], [MELTING] or [READY].
To Turn the Appliance OFF :
(See Note 1) Press Rocker Switch
Off., Display will show:
The Software number and then [OFF] [OFF] on
single vat or a dual vat if both sides are off.
Note 1: Use Left Rocker Switch for left side and Right
Rocker Switch for the right of dual vat control.
Keys Key Indicators
12 Product 12 Product
Key KeyKey
Thermometer ClockProgram
OPERATIONS
To Check Actual Temp : Press , Display shows actual temp and then returns to normal mode.
To Check Set Temp : Press , Display shows set temp and then returns to normal mode.
To Check Cook, Shake and Hold Time : Press then the Product Key desired. See example below:
Typical displays using key 4 as an example:
Key 4 set for 3 minutes and 28 seconds cook time.
Key 4 Shake Time is set for 2 minutes and :00 seconds before the end of the
Cook.
Key 4 Hold Time in set for 10:00 minutes.
In a few moments, the display will return to [READY] or last mode of operation.
To Check Time Remaining on a Non-Displayed Product Key when Multiple Timers are in Use :
Press then the Product Key of the Non – Displaying timer key, The display will switch from showing the lowest
time remaining over to the time remaining for the key that was pressed. Repeat for other keys.
To Start a Cook : When display shows [READY] Press any [L,1,2,3,4,5,6,7,8,9,0,R] Product Key to start cook timer.
The indicator light above will flash to indicate the timer is running:
To End a Cook : When the audible alarm is beeping, press the appropriate Product Key
4
(i.e. Key 4) with the
flashing indicator light, all other indicator lights are off until the key is pressed.
To Cancel a Cook : Press and Hold the Product Key you want to cancel until its indicator light is off.
Boil Out Mode : After filling empty vat with water, turn appliance on.
Automatic Entry : When the water temperature reaches just below 212
o
F (100
o
C) the
computer will display.
, press Product Key to continue heating,
display then shows .
Manual Entry : Press then enter Product Key [2] [1] [2] for Fahrenheit or [1] [0] [0]
for Celsius display unit. When last digit is entered, boil mode will start automatically. On
Dual Vat computers both sides will enter boil mode. You must turn off both sides of the fryer
to exit Boil mode.