Installation Manual - Front Side

INFS2019-1-PC/EN

Installation instructions Front Side

1. Determine the dimensions of the cabinet and cut the support

beams with the saw. ATTENTION! Correct length of the beam =

the dimension of cabinet on the inside - 4 mm.

2. Place the inserts into the ends of the beams that have been

cut to size.

3. Place the beams between the cabinet and position it against

the under side of the PITT

cooking unit. ATTENTION: FOR THE

POSITIONING, SEE STEP 4.

4. Position the beams in such a way that the screws, gas

connection and the electricity block are freely accessible.

* Minimum distance of 80 mm

5. Push the beams firmly against the underside of the PITT

cooking unit and tighten the lower two screws by hand. Repeat

this step for the other side of the cabinet.

6. Push the beams firmly against the underside of the PITT

cooking unit and tighten the upper two screws completely.

Then, tighten the lower screws completely.

Contents of package: Tools needed:

• Measuring tape

• Cross-point screwdriver

• Metallic saw

2x support beams

4x inserts

16x cross-point screws 4,2x16 mm

www.pittcooking.com

Instructions for installation of support set

PAGE 1
Instructions for installation of support set Contents of package: 2x support beams Tools needed: • Measuring tape • Cross-point screwdriver • Metallic saw 4x inserts Installation instructions Front Side 16x cross-point screws 4,2x16 mm 1. Determine the dimensions of the cabinet and cut the support beams with the saw. ATTENTION! Correct length of the beam = the dimension of cabinet on the inside - 4 mm. 2. Place the inserts into the ends of the beams that have been cut to size.
PAGE 2
Installation instructions Front Side S ! S S S 2. Carefully press the sealing ring over the edge of the heat shield. Check whether the ring fits well in its entirety. 1. Overview of the various parts. ! S S 10. Note: the adhesive strip under the sealing scale of the knob may not yet be removed. 3. Overview of the set screws (S). ! ! 4. Turn all set screws back to approximately 3 mm above the unit. Then place the heat conductor on the unit. 5.