Installation and Handling Instructions

Manufacturing recesses (cut-outs) | Solid Surface

The guidelines of the manufacturer of the Solid Surface material should always be strictly

followed.

In case of Solid Surface the following extra instructions apply:

3a. Use a router or CNC machine to prevent jagged recesses.

Radius R = 3 mm

Fig. 10 Fig. 11

Extra plate Solid Surface

3b. Glue an extra Solid Surface plate at all times at the bottom of the worktop. This plate should

have the same measurements as the PITT cooking heat conductor, and the same thickness as

the worktop (fig. 10).

3c. A range of minimum R=3 mm should be applied on the top and bottom of the recess(es). By

sanding it smooth afterwards, possible cracks can be prevented (fig. 11).

3d. If the worktop has been thickened, a ladder frame must always be applied (fig. 12).

For the correct dimensions of the ladder frame, we refer you to the instructions of the

manufacturer of the Solid Surface product.

We advise to use a ladder frame at all times.

Fig. 12