Installation Guide
A. Cut the horizontal spacers for each course to t
the opening.
B. Insert an anchor into
the ends of the horizontal
spacers where they meet a jamb.
C. Apply two 1/4" beads of sealant to the edges of
the horizontal spacers 1/4" in from edge of spacer.
Place spacer sealant side down.
D. Then apply two 1/4" beads of sealant to this same
horizontal spacer, 1/4" in from edge of spacer.
E. Attach anchor to jamb with screws. Cut expansion
strip to 7-1/2" length (for 8" high glass block).
F. Place expansion strip over the anchor and against
the jamb.
A. Place a glass block in the opening against jamb.
B. Apply two 1/4" beads
of sealant behind the
raised edge of glass
block.
C. Press a vertical
spacer into place
next to the block.
D. Apply two 1/4" beads
of sealant behind the
raised edge of the
next glass block to
be inserted.
E. Insert this next block
tight against the
vertical spacer and
apply two 1/4" beads
of sealant behind the
raised edge of block.
F. Continue inserting
spacers and blocks
in this manner to
complete the row.
G. Check the rst row
for alignment of
spacers and blocks.
Make sure all the
blocks are level and
the joints are tight.
3B
2F
3C
3E
2B
2D
13 14
2E