Instructions / Assembly

22
S. Install a vertical panel anchor after
the second block and screw the
short leg of the anchor
to the curb. All panel
anchors should be
attached using #12 x 1"
zinc-plated head screws.
Use two screws per
anchor.
Note: If attaching the
panel anchors to tile
or masonry, plastic
screw anchors should
be used.
T. Apply mortar so that the long
leg of the anchor is embedded
in the vertical joint.
4S
4T
U. Follow this procedure for the rest of the blocks in the
fi rst row, installing a panel anchor after every
2 blocks.
V. Check periodically to ensure that the glass blocks
are straight, level and plumb.
Note: If you fi nd a problem, adjust the block into
place with a rubber mallet before proceeding.
W. Using a polyfoam brush, remove
excess mortar and fi ll any voids on
both sides of your panel.
4W