User's Manual

Table Of Contents

Cautions before use Cautions before use

Make sure the camera and Expert are powered off before install device.

As this is an electronic product accessory; some of the environment causes may affect the

working. However this is hardly ever to get this situation.

When connected the remote cable with the device, do not pull the wires.

This product can't be strong vibration, or may lead to product failure.

For a long time non-use, please turned off the view transmitter and the receiver's power and

remove the battery.

Do not put it in high temperature, such as a closed car under direct sunlight, the control panel

and other high-temperature areas.

Keep dry, do not use wet hand contact with the product, the product must not be immersed in

water or exposed to rain, and this may lead to not work properly.

Do not use flammable gases in violation of this warning may cause an explosion or fire.

Because this product include battery, regarding how to use and charge battery, please operate it

strictly according to related rules, otherwise may cause explosion, fire or physical injury.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.