User's Manual

Transmitter and receiver both have a power switch. Move it to ［ ］ turn on;
move it to ［ ］ turn off.
Turn power ON and OFF
Expert Transmitter
Expert Receiver
Expert Transmitter:
When power on, the POWER LED continuously bright as red. When the power
supply voltage is not able to maintain equipment working, the POWER LED would
flash quickly.
Expert Receiver:
When turn on the power, the STATUS LED shows the receiver is on; the STATUS
LED off after starting up, and the screen shows [PIXEL Expert] and begins to
search signal of transmitter; LCD screen shows the image after received the signal.
* If fail to search out signals under the same channel, the screen would shows
[Disconnected], until it gets the same channel.
* If fail to search out signals under the same channel, switch receiver channel to
search other channels signal.
* When the power supply voltage is not able to maintain equipment working, the screen would shows
image of power low, and then the STATUS LED would quickly flash red.
Battery Installation
1. Slide and open battery hatch.
Transmitter uses 4 AA batteries; available to use rechargeable or
alkaline battery.
2. Install the battery according to the signs on the battery hatch.
When using 1.2V 2400mA battery, standby for 100 hours, working
time over 10 hours.
When the battery is low, POWER LED INDICATOR would flash as red.
The battery should be replaced or recharged immediately.
UsageUsage
1 3
1 2
1 3