User's Manual

2 32 2
2s
2s
EnEn
How to use the receiver of Knight TR-331RX
How to use the receiver of Knight TR-331RX
1. When first install the batteries in the receiver, the
LCD will show[ ], as shown.
Function mode setting
The first letter “ ” means that the receiver was set as
group A, “ ” means the communicating channel of the
device, 15 frequency channels can be selectable.
2. Press [ SET ] button and hold for 2s to set the
group mode of Knight TR-331RX, the LCD will
show [ ], the receiver default as group A.
3. Slightly press [SET] or [POWER] button to set the
next group, 5 groups A to E will need to be set.
4. Press [SET] and [POWER] at the same time to save
the setting and exit.
5. It's available to set all the functions through
transmitter which installed on the camera.
Knight TR-331RX channel setting
1.
and button 2s at same time for communicate
channel setting of the receiver.
2. After pressed the [ CH- ] and [ +CH ] button, LCD
display shown [ ] , " " means channel
number, such as shown , enter the setting mode.
Turn on the Knight TR-331RX power ,press
[ +CH ]
[ CH- ]
3. When the LCD display shown [ ] , Press[ CH- ]
or [ +CH ] to set of wireless channel, press[ CH- ] to
reduce the number, [ +CH ] to increase the numbers.
The channel can be set from 01-15, Avoid multiple sets
in the same area at the same time using the Knight
TR-331 device then mutual interference will occurred.
4. Press the button[ CH- ] and [ +CH] again, the mode will
be saved and enter to standby mode in 4s when no any
action.