Operation Manual

Using of battery

Install the battery

Using of flashgun power pack

1 0

1 1

When replacing batteries, replace all four batteries of each set at the same

time. Do not mix battery types or brands or use old with new batteries.

When installing batteries, turn off the power of the flashgun and never reverse the

polarity of the batteries.

If the battery terminals become soiled, remove dirt and smudges before use,

as this may cause contact failure.

Battery power tends to weaken as the temperature drops. It also gradually

decreases when batteries are not used for a long time and recovers after a

short break following intensive use. Be sure to check battery power and

replace the batteries with fresh ones if you notice any delays in the recycling

time.

Do not store batteries in locations subject to high temperatures and high

humidity.

Flash photography consumes a large amount of energy, batteries may not

operate fully before reaching the end of their stated lifespan or number of

charges as specified by the battery manufacturer.

Use the same type of four or eight AA type refill batteries of any of the following

types.

1. Slide the battery hatch while pressing the lock release

button at the middle of the battery hatch lid, then pull out

the battery hatch.

2. Install batteries according to the illustration inside the

battery hatch.

Frist, insert the - pole into battery hatch, then press into the + pole.

Flip over the battery hatch and push out the battery from this hatch.

Alkaline-manganese(1.5V)

lithium(1.5V)

Ni-MH(Nickel Metal Hydride)(1.2V)