Operation Manual

1 5
1 4
Open the background light of display
Preparation for installation and usePreparation for installation and use
Press and hold the background light button for 2 seconds, the
background light will be turned on.
Open the background light of the receiver and press the button
twice each 6 seconds, the background light will keep lit.
The background light will not be close by hand; it will turn off
after 6 seconds automatically without any operation.
Press and hold the background light button for 2 seconds, the
background light will be turned on.
Open the background light and press the button twice each 6
seconds, the background light will keep lit.
The background light will not be close by hand; it will turn off
after 6 seconds automatically without any operation.
The transmitter(TW-282TX)
The receiver(TW-282RX)
2s
2s
Receiver connected with the camera
Make sure your receiver has been installed in place and to
ensure that cameras and receivers are shut down.
First, insert the input plug of the shutter connect cable into
the receiver's output control signal socket in place.
The timer remote control will not be able to control the camera if the
shutter connect cable didn’t insert correctly.
Fix the camera on the tripod or other fixed frame.
protective cover of external shutter socket and put the
shutter plug of shutter connect cable in place, then make
sure it has been fixed firmly.
Open the
For most of camera shutter socket, there is a mis-plug interface,
please note insert direction so as to avoid damage to shutter socket.
Turn on the receiver' s power and then the camera's power.
1.
2.
3.
4.