Installation Guide

2
HARD SURFACE/CEILING/
WALL MOUNT INSTALLATION
1 Carefully unpack FlatLight from its packaging. Properly inspect for
defects before installing. Wear work gloves in order to prevent dirt
or oil from being transferred to the FlatLight.
2 Remove mounting plate from Flatlight.
3 Turn off the electric power to the junction box location at the main
fuse or breaker panel.
4 Remove existing lighting fixture or cover plate from junction box.
5 Extract the circuit wires from the junction box
and separate the three wires. There will be a
black wire, referred to as the "hot" lead, that
carries the current to the fixture, a white or
"neutral lead" that carries the current back to
complete the circuit and a green or bare
copper grounding wire.
6 Remove 1/2 inch of the plastic wire covering, called insulation, from
each of the circuit wires using wire strippers or a utility knife.


A
Continued on next page...
ENGLISH