Installation Guide

13 Connect the bare copper or green grounding wire from the junction
box to the green insulated wire from the FlatLight by placing them
together and screwing a wire nut onto the ends.
14 Place the connected electrical wires into the junction box and install
the FlatLight to the mounting plate by aligning mounting clips to the
slots located on the light. Once aligned slide FlatLight into place.
Go to step 16 if not using a mounting plate.
15 Light can be installed using the 4 tabs
located on the back of the FlatLight.
Perfect for under counter installations.
16 Remove protective film from the face of the FlatLight.
17 Turn electric power back on to junction box.
HARD SURFACE/CEILING/WALL MOUNT
INSTALLATION CONTINUED
4
ENGLISH