Installation Guide

20cm minimum distance has to be able to be maintained between the antenna and the users for the

host this module is integrated into. Under such configuration, the FCC radiation exposure limits set forth

for an population/uncontrolled environment can be satisfied.

USERS MANUAL OF THE END PRODUCT:

The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled

environment can be satisfied. The end user has to also be informed that any changes or modifications

not expressly approved by the manufacturer could void the user's authority to operate this equipment. If

the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required

to be available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful interference and (2) this device

must accept any interference received, including interference that may cause undesired operation.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains FCC ID:

2AWVMPG11". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19

statement has to also be available on the label: This device complies with Part 15 of FCC rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful

interference and (2) this device must accept any interference received, including interference

that may cause undesired operation.

That module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).

That separate approval is required for all other operating configurations, including portable

configurations with respect to Part 2.1093 and different antenna configurations.

This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance

requirement of the end product, which integrates this module.