Instructions

44
ABNORMAL MOTOR-SMELLS.
1. Motor defective.
1. Replace motor.
SMEAR OF OIL.
1. One-way valve is leaky.
1. Seal the valve.
APPLIANCE VIBRATES.
1. Motor not properly fixed.
1. Fix motor properly.
2. Hood not properly fixed.
2. Fix hood properly.
INSUFFICIENT EXTRACTING CAPACITY.
1. Too much distance hood-hob.
1. Lower position of hood.
2. Too much draught because of open
doors and/or windows.
2. Close the doors/windows.
APPLIANCE IS UNSTABLE.
1. Screws are not firmly tightened.
1. Tighten the screws.
IF THE HOOD DOES NOT WORK PROPERLY AND/OR YOU CAN HEAR
INCREASED OPERATING NOISE, CHECK THE SCHEDULE BELOW:
❖ Incorrect dimension of the air duct.
❖ Obstruction in the air duct.
❖ The diameter of the air duct from hood to wall-box inclusive should be 120 mm;
otherwise the capacity of the motor may be decreased.
❖ If you have installed a fly screen on the wall-box, the air vent may be obstructed.
Check by removing the fly screen.
❖ If the cover panel of the wall box is equipped with firm and slanted slats, the air
vent may be obstructed. Check by removing the cover panel.
❖ Install a cover panel with moveable slats, which do not obstruct the air vent.
❖ Check condition and cleanliness of the filters.
❖ Check if the air which is extracted by the hood is replaced to avoid negative
pressure.
❖ When you run your appliance in recirculating mode, check if the carbon filter has
been replaced on time (min. every 3-6 months).
If the appliance has a malfunction not noted on the schedule or if you have
checked all items on the schedule but the problem still exists, please contact the
shop you purchased the appliance at.