SDS

M A T E R I A L S A F E T Y D A T A S H E E T
Date Printed: 03/25/14 Page: 1
3
LARGE SPILL: Floor may be slippery, use care to avoid falling. Contain spills immediately
with inert materials (e.g. sand, earth). Transfer liquids and solid diking material to separate
suitable containers for recovery or disposal. Caution: Keep spills and cleaning runoff out of
municipal sewers and open bodies of water.
7. HANDLING AND STORAGE
HANDLING: Avoid employee exposure through the use of appropriate engineering controls,
adequate personal protective equipment, and good industrial hygiene practices. Wash
thoroughly after handling. Handle in well-ventilated workspace.
STORAGE: Store in a moderate cool, dry, well ventilated area away from direct sources of
heat. Avoid freezing (32F). Position containers so that any labeling information is visible.
Keep containers closed.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS: The use of local exhaust ventilation is recommended to
control emissions near the source. Additional engineering controls should be used as
necessary.
RESPIRATORY PROTECTION: Respiratory protection is generally not required. A
respiratory protection program meeting OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use.
SKIN PROTECTION: Impervious clothing should be worn when gross contact is likely, such
as when cleaning up large spills. Neoprene gloves may provide protection against permeation.
EYE PROTECTION: Use safety glasses with side shields (ANSI Z87.1 or approved
equivalent).
9. PHYSICAL AND CHEMICAL PROPERTIES
BOILING POINT: 212 Deg. F
MELTING POINT: Not determined.
VAPOR PRESSURE: Not Determined
VAPOR DENSITY: Not Determined.
SOLUBILITY IN WATER: 100% Soluble or dispersible.
SPECIFIC GRAVITY: 1.06
PH: 4.5 to 5.0
ODOR: Mild, sweet.
APPEARANCE: Blue white.