CONTENTS Precautions................................................................................................................................................. 1 How to Handle Discs.............................................................................................................................. 1 Lithium Battery Cell Warnings................................................................................................................ 1 Installation .......................................
PRECAUTIONS How to Handle Discs Handle a disc by its edges. Do not touch the playing side. Before inserting a disc, wipe the disc outward from the disc center with a clean, soft, dry and lint-free cloth. Do not use solvents or thinners such a petrol/benzene or cleaners. After removing a disc from the disc slot, place the disc in a sleeve or case to keep it clean and prevent scratches. Do not stick paper or tape on the disc surface.
INSTALLATION Prepare Radio 1. 2. Before you begin, disconnect the battery negative terminal. Remove the transport screws. 3. Remove chassis from the mounting sleeve. BRACKET KEY PLASTIC TRIM OUT BRACKET KEY If you want to remove the chassis from the mounting sleeve, remove the plastic trim out from both sides. Next, insert the two bracket keys into the left and right side of the chassis, as illustrated, to separate the chassis from the housing.
INSTALLATION (CONT.) INSTALLATION DIAGRAM DASH BOARD HEX NUT METAL MOUNTING STRAP SPRING WASHER PLAIN WASHER TAPPING SCREW CONSOLE MOUNTING SLEEVE HEX BOLT ! - Only use speakers with 4 ohm impedance. - The maximum current of the Amp Remote trigger is 200mA.
CONTROL PANEL BUTTON LOCATIONS 1. (power),Volume knob and SEL (select/menu) button 2. SRC (source) button 3. AMS (automatic store / preset station scan, automatic music search) button 4. (pause/play), Preset station1 button 5. INT (intro) , Preset station 2 button 6. RPT (repeat) , Preset station 3 button 7. RDM (random) , Preset station 4 button 8. -10(previous 10 tracks) , FLR-(previous folder), Preset station 5 button 9. +10(next 10 tracks) , FLR+(next folder), Preset station 6 button 10.
GENERAL OPERATION Turn Unit On/Off Press any button on the front panel or on the remote control to turn on the unit. Press and hold the power (VOL knob) button on the front panel or briefly press the power ( button on the remote control to turn the unit on or off. Adjust Volume (VOL) Rotate the V O L knob on the front panel or press the V O L control to increase or decrease the volume level.
GENERAL OPERATION Rotate the V O L knob on the front panel or press the V O L control to adjust the selected item. /VOL button on the remote Set the Clock (CLK) 1. To display clock time, press the CLK button. 2. To set clock time, press and hold the CLK button and the hour will flash. 3. Press the or button on the front panel or on the remote control to adjust the hour. 4. Press the CLK button and the minutes will flash. 5.
RADIO OPERATION Switch Between USA area and Europe area Frequency In radio mode, press the VOL button to enter the switch state of the US(USA) and EU(europe) frequency, then rotate it to switch between US(USA) and EU(europe) frequency. The system will change the frequency setting in about 3 seconds. Change Bands (BAND) Press the BAND button to switch between the FM1, FM2, FM3,AM1 andAM2 bands. Each band stores up to six preset stations.
DISC/USB/CARD OPERATION To insert DISC / USB / SD CARD To play files on a disc, insert a disc with the label surface facing upward into the disc slot. Playback will begin automatically. Label surface up To play files in a USB device, open the USB port & micro SD card slot cover, then insert a USB storage device into the USB port. Playback will begin automatically. To play files in an micro SD card, open the USB port & micro SD card slot cover, then insert an micro SD card into the micro SD slot.
DISC/USB/CARD OPERATION Select the track or file for playback in MP3 format Press the AMS button repeatedly to select one of the following 3 search modes: NUM SCH (Searching by track or file serial number) DIR SCH (Searching by folder serial number) FILE SCH (Searching by track or file name) Searching by track or file serial number: a) In playback of files with MP3 format, press the AMS button once to access the track or file number searching mode which allow you to quickly find a specific MP3 track or file
BLUETOOTH OPERATION Pair and Connect Prior to using the Bluetooth device as a handsfree system for a Bluetooth-enabled mobile phone for the time, you must pair and connect the two devices as follows: in the LCD indicating 1. In any mode, prior to pairing and connecting, the BT logo that no device is connected. To begin pairing, enable BT mode on your mobile phone. the car audio system, the PLANET P385UAB will be displayed. 2. When the phone 3.
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. When the lithium cell battery becomes weak, replace it as illustrated on the right. 2. Press and hold the movable block in the direction indicated by arrow 1.
TROUBLESHOOTING The following chart will help in solving most problems that may occur. If you still have questions after going through the checklist, please consult your local customer service representative. Before going through this check list, refer the wiring and operating procedures. Symptom Cause Solution The car ignition switch have not turn on. If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse has been blown.
SPECIFICATIONS General Chassis Dimensions.....................................................................178(W) x 160(D) x 50(H) mm Power Supply Requirement........................................................................................... DC 12V Current Consumption ..................................................................................................15A MAX Maximum Power Output ...........................................................................................