Owner's Manual
Table Of Contents
I
INFORMATION
TO
THE USER
FCC COMPLIANCE STATEMENT
This device complies with part 15
of
the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation
of
this device.
This transmitter must not
be
co-located or operated
in
conjunction with any other
antenna or transmitter. The Bluetooth antenna cannot be removed (or replaced) by
user. This equipment complies with FCC/
IC
radiation exposure limits set forth for
an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-1 02
of
the
IC
radio frequency (RF) Exposure rules. This
equipment has very low levels of
RF
energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable that it should
be
installed and operated keeping the radiator at least 20
em
or more away from
person's body (excluding extremities: hands, wrists, feet and ankles). Alteration
or modifications carried out without appropriate authorization may invalidate the
user's right to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15
of
the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
in
a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in
accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur
in
a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more
of
the following measures:
o Relocate or reorient the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into
an
outlet on a circuit different from that to which the
receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.