User Manual

3
INSTALLATION (CONT.)
INSTALLATION
DIAGRAM
Wiring Connections
Removal of the Main Unit
1. Remove the metal strap from the main unit.
2. Remove the plastic trim out from the main unit.
3. Insert a bracket key into the left and right side of the main unit and draw the unit out of
the mounting sleeve.
HEX BOLT
SPRING WASHER
PLAIN WASHER
TAPPING SCREW
HEX NUT
DASH BOARD
METAL MOUNTING STRAP
CONSOLE
MOUNTING SLEEVE
- Only use speakers with 4 ohms impedance.
- The maximum current of the Amp Remote trigger is 200mA.
!
- The equipment shall be protected by the circuit with max. 10 Amperes of the
front end of DC source.
White
Front Left
Speaker
Rear Left
Speaker
Front Right
Speaker
Rear Right
Speaker
White/Black
ACC + (Red)
GND - (Black)
ANT + (Blue)
Power B+ (Yellow)
Gray/Black
Purple
Purple/Black
Green
Green/Black
Gray
1. AUX-L: AUX Input - Left CH (White)
2. AUX-R: AUX Input - Right CH (Red)
3. FL: Front Left PRE-AMP Output (White)
4. FR: Front Right PRE-AMP Output (Red)
5. RL: Rear Left PRE-AMP Output (White)
6. RR: Rear Right PRE-AMP Output (Red)
10A
ANT
F-R R-R
F-L
AUX-R
AUX-L
R-L