User's Manual

Using The EgoUsing The Ego

Using The Ego

Before you can begin to use your Eclipse Ego, there are a few necessary

components that are required to enable the Eclipse Ego to function; namely

an air system and a loader of your choice.

Every Eclipse Ego comes complete with an Eclipse On/Off Purge System

(OOPS) allowing a preset regulator and tank to be screwed straight in for

immediate use. Before screwing the preset system into the OOPS ensure

that the on/off knob is wound out approximately half way

(See Figure 3.1)

. Be

careful not to unscrew the on/off knob too far as it will come completely out

of the OOPS. If this happens, replace the on/off knob by screwing it back

into the OOPS in a clockwise direction.

Screw the preset air system into the OOPS

(See Figure 3.2)

so that the bottle

screws in all the way and is tight. Slowly turn the on/off knob in a clockwise

direction allowing the OOPS to depress the pin of the preset air system,

causing the Eclipse Ego to become pressurised, providing there is sufficient

air in your tank

(See Figure 3.3)

. You have now installed a preset air system

to your Eclipse Ego.

FIGURE 3.1

FIGURE 3.2

FIGURE 3.3

Installing a Preset Air System

Setting Up

Note: When utilising an OOPS on your Eclipse Ego, the Eclipse

Ego will store air in the valve chamber after the OOPS has dumped

the supply in your gas line and inline regulator. Please remember to

discharge the stored air in a safe direction as you are unscrewing the

on/off knob on the OOPS.

Note: The Eclipse Ego cannot be used with Co2, it can only be

Using The Ego