Manual

THE MODE
PARAMETER
The MODE parameter is used to control the ring mode of the Ego. Each of the
selectable modes has its own features as outlined below:
SEM1 (Semi 1) - This is the default ring mode which produces one shot for
every pull of the trigger and is uncapped with the Break-Beam Sensor System
(BBSS) enabled.
SEM2 (Semi 2) - This mode is the same as the Semi 1 mode but the maximum
rate of re is capped at 15bps.
RMP1 (Ramp 1) - This mode allows the rate of re to ramp to a maximum set
by the ROF CAP parameter once the trigger has been pulled four times at a
minimum rate of 5 pps (pulls per second), and allows this rate of re to be
maintained as long as trigger pull rate is maintained. After the last trigger
pull, the ramp can be restarted with a single pull if that pull occurs within one
second.
RMP2 (Ramp 2) - This mode is the same as the Ramp 1 mode but without the
1 second ramp restart.
RMP3 (Ramp 3) - This mode is the same as the Ramp 2 mode but activates at
a minimum rate of 7.5 pulls per second.
TRNG (Training) - This mode is the same as the Semi 1 mode but the rammer
is prevented from striking the exhaust valve, the BBSS is permanently
disabled and the rate of re is uncapped. This mode is compatible with the
neighbours!
PLEASE NOTE: Certain modes may only be available in certain countries and
on certain models of the Eclipse Ego. If in doubt, the current ring mode is
displayed at all times on the main screen.
ADJUSTING THE
MODE PARAMETER
THE TIMING MENU
Scroll through the SET-UP menu until the MODE parameter is displayed. The
current ring mode is shown on the right-hand sde of the display. To change
the MODE parameter press and the edit indicators will appear. You have
now entered the MODE parameter. The options for the MODE parameter are
displayed below:
SELECT
FWD / RAISE
BACK / LOWER
Press the button to scroll down through each of the available ring mode
options. Once the last option has been displayed, pressing the button
will cause the rst option to be displayed.
Press the button to scroll up through each of the available ring mode
options. Once the rst option has been displayed, pressing the button
will cause the last option to be displayed.
Press the button to change the ring mode to the displayed option.
Selecting BACK will return the display to the SET-UP Menu.
Press the button to scroll down through each of the items on the TIMING
Menu. Once the last item has been displayed, pressing the button will
cause the rst item to be displayed.
Press the button to scroll up through each of the items on the TIMING
Menu. Once the rst item has been displayed, pressing the button will
cause the last item to be displayed.
Press the button to edit the displayed parameter.
Selecting BACK will return the display to the SET-UP Menu.
SELECT
FWD / RAISE
BACK / LOWER
The TIMING Menu provides access to parameters which control the Ego’s
ring cycle.
Scroll through the Set-up Menu until TIMING is displayed and then
press .This will display ROF CAP the rst item on the TIMING Menu.
28
ADVANCED SET-UP
29
ADVANCED SET-UP
QUICKGUIDE