User's Manual

ATTACHING
A LOADER
Using a 5/32” hex key, turn the top screw of the clamping
feed neck counter clockwise (SEE FIGURE 5.1).
Release the clamping lever on the feed neck (SEE FIGURE 5.2) and
test to see if your loader can easily be pushed into the top of
the feed neck. If the loader cannot easily be pushed into the
feed neck, loosen the top screw of the clamping feed neck a
little more by turning it counter clockwise using a 5/32” hex
key (SEE FIGURE 5.1).
When you have managed to push your loader into the
clamping feed neck, close the clamp to secure it rmly in
place (SEE FIGURE 5.3). If the loader is loose then you will need
to release the clamp, tighten the screw slightly by turning
it clockwise with a 5/32” hex key and closing the clamp.
Repeat this process as necessary to secure your loader in
place.
You have now attached a loader to your Eclipse Ego7. Once
you have lled your loader and air tank you will then be ready
to begin using your Eclipse Ego7.















