User's Manual
UNDERSTANDING
THE BBSS OPERATION
The BBSS is able to switch itself off in the event that a
blockage or contamination prevents it from functioning
correctly. In this instance, the BBSS will switch itself back on
once the blockage is cleared and the correct operation can
be resumed.
The BBSS icon on the main screen is used to indicate the
eight possible states of the BBSS as follows:
The Ego7 can be red at the maximum rate of
re determined by the chosen ring mode.
The sensor has been re-enabled. A ball is
detected and the Ego7 can be red at the
maximum rate of re determined by the chosen
ring mode.
The Ego7 cannot be red.
The sensor is enabled. No ball is detected so
the Ego7 cannot be red. To reset the BBSS
icon, use the button to switch off the BBSS
and then back on again.
The Ego7 can be red at a maximum rate of
re as set by the OFF ROF
parameter
(SEE PAGE 32)
The BBSS has been over-ridden as the user
has selected training mode. As the user has
chosen to leave the BBSS on, the achievable
rate of re is limited by the MAX ROF
parameter.
The system is disabled. The Ego7 can only
be red at a maximum rate of re of 10bps,
regardless of the chosen ring mode.
The BBSS has been over-ridden as the user
has selected training mode. As the user has
chosen to turn the BBSS off, the achievable
rate of re is limited by the OFF ROF
parameter.