User's Manual

THE MODE
PARAMETER
The MODE parameter is used to control the ring mode of
the Ego7. Each of the selectable modes has its own features
as outlined below:
ADJUSTING THE
MODE PARAMETER
Scroll through the SET-UP menu until the MODE parameter
is displayed. The current ring mode is shown on the right-
hand side of the display. To change the MODE parameter
press and the edit indicators will appear. You have now
entered the MODE parameter. The options for the MODE
parameter are shown below:
Press the button to scroll down through each of the
available ring mode options. Once the last option has been
displayed, pressing the button will cause the rst option
to be displayed.
Press the button to scroll up through each of the
available ring mode options. Once the rst option has been
displayed, pressing the button will cause the last option
to be displayed.
Press the button to change the ring mode to the
displayed option.
Selecting CANCEL will return the display to the SET-UP
Menu.
PLEASE NOTE: CERTAIN MODES MAY ONLY BE AVAILABLE
IN CERTAIN COUNTRIES AND ON CERTAIN MODELS OF
THE ECLIPSE EGO7. IF IN DOUBT, THE CURRENT FIRING
MODE IS DISPLAYED AT ALL TIMES ON THE MAIN SCREEN.

This is the default ring mode which produces one shot
for every pull of the trigger and is uncapped with the
Break-Beam Sensor System (BBSS) enabled.

This is an assisted mode of re that allows the rate of
re to RAMP to a higher level than the users number of
trigger pulls per second.
