User's Manual
SETTING THE
BAND LOW VALUE
The BAND LO parameter is only available if OPTO has been
selected in the HARDWARE menu. BAND LO denes the
point at which the trigger is considered released.
Scroll through the FILTER Menu until the BAND LO
parameter is displayed.
The current value of the BAND LO setting is shown on the
bottom right hand side of the display see below.
Press the button to enter
the edit function and the edit
indicators will appear on the
display.
Press and release the button
to increase the BAND LO value
in increments of 1%. Press and
hold the button to increase the
BAND LO value more rapidly.
Press and release the button
to decrease the BAND LO level
in increments of 1%. Press and
hold the button to decrease the
BAND LO value more rapidly.
Press to save the BAND LO
value and the edit indicators will
disappear from the display to
indicate that the value has been
accepted.
You have now returned to the
FILTER Menu.
BASIC TRIGGER
FILTER SET-UP
95% of trigger bounce problems can be eliminated by
utilizing one of the nine xed DEBOUNCE parameters
(DEBOUNCE 1-9). In attempting to eliminate trigger bounce
it is advisable to try the ve xed DEBOUNCE parameters
before attempting any advanced set up of the trigger lters.
ADVANCED TRIGGER
FILTER SET-UP
In order to optimize the ID FILTER it is necessary to have the
BAND HI parameter set as high as possible and the BAND
LO parameter set as low as possible:
1. Select the BAND HI parameter. Observe that the
graphical bar rises and falls as the trigger is pulled and
released. The actual value of the graphical bar is displayed in
the top right of the display.
2. Set the REAR STOP TRIGGER SCREW as required,
ensuring that the bar is as close to 100% as possible when
the trigger is fully depressed against the set screw. It is
advisable to allow for some extra travel in the trigger pull
once the bar has reached its maximum value.
3. Adjust the BAND HI parameter so that when the trigger is
fully depressed the bar settles above the indicator on the left
hand side of the screen (SEE PAGE 42).
4. Select the BAND LO parameter. Observe that the
graphical bar rises and falls as the trigger is pulled and
released. The actual value of the graphical bar is displayed in
the top right of the display.