User's Manual

(CONTINUED)
Remove the rubber nger detent and using a dry Q-tip clean
the detent and it’s location point in the Eclipse Ego7 Body.
Replace clean detent back into the Eclipse Ego7 body
(SEE FIGURE 9.4) and slide sensor unit back into place (SEE FIGURE 9.5).
Replace the Sensor Cover and using a 5/64th" hex key,
replace the Bream Beam Sensor Cover retaining screw to
hold the sensor cover in place (SEE FIGURE 9.6).
Be careful not to cross-thread the screw. Do not over
tighten the screw.
Repeat procedure for opposite side of the Eclipse Ego7.
You have now cleaned your Break-Beam Sensor System.
NOTE: WHEN CLEANING BREAK-BEAM SENSOR SYSTEM
INSPECT CONDITION OF RUBBER FINGER DETENTS AND
REPLACE IF NECESSARY. ENSURE THAT THE RECEIVER
SENSOR (INDICATED BY A RED MARK & RED HEAT
SHRINK) IS LOCATED ON THE RIGHT-HAND SIDE OF THE
MARKER BODY.















