User's Manual

THE EGO9 SOLENOID
ASSEMBLY
With the frame separated from the Ego9 body and the
Solenoid Assembly and BBSS Assembly unplugged
from the circuit board (see page 63) use a 5/64” hex
key to undo and remove the two screws that hold the
Solenoid Assembly onto the Ego9 body (SEE FIGURE
16.1).
With the Solenoid Assembly completely removed
from the Ego9 body the bottom of the Ego9 body
should now resemble FIGURE 16.2 Ensure that the air
transfer holes in the bottom of the body are free from
contamination from any dirt, debris, paint or moisture
and clear away any excess grease if it appears to be
blocking any of the transfer holes.
Check the underside of the Solenoid Assembly to
ensure that it is also free from damage or debris (SEE
FIGURE 16.3) .Remove and clean the rubber gasket
as shown in FIGURE 16.4. Replace the rubber gasket
ensuring that it lies flat in its designated groove in the
minifold body (SEE FIGURE 16.5).
If you are replacing a defective Pilot Assembly, unscrew
it from the minifold and replace it with a new Pilot
Assembly unit (SEE FIGURE 16.6).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
(CONTINUED)
Replace the Trigger Spring into the spring hole in the
top of the trigger and position the trigger so that the
hole through the trigger lines up with the holes in the
bearing carrier, slide the trigger pin in place (SEE FIGURE
15.6).
Gently lower the trigger assembly and bearing carrier
into the frame, taking care not to damage the micro-
switch or the Opto sensor, and ensuring that the trigger
is positioned correctly (SEE FIGURE 15.7). Using a 5/64”
hex key tighten the two screws that hold the bearing
carrier in place in the top of the Ego9 frame (SEE FIGURE
15.8). Using a 1/16” hex key tighten down the trigger
pin retaining set screw (SEE FIGURE 15.9).
You have now stripped and cleaned your Ego9 trigger.
NOTE: DO NOT FULLY TIGHTEN THE TRIGGER PIN RETAINING
SCREW UNTIL THE BEARING CARRIER HAS BEEN SECURED
IN THE FRAME. THIS IS TO ENSURE THE TRIGGER PIN IS
CORRECTLY LINED UP AGAINST THE SIDE WALL OF THE
FRAME.
FIG 16.2 FIG 16.3
FIG 16.4
FIG 16.5
FIG 16.6
FIG 16.1
FIG 15.8
FIG 15.7
FIG 15.6
FIG 15.9
66.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
67.
MAINTENANCE
MAINTENANCE
QUICK GUIDE