Manual

(CONTINUED)
Remove the rubber finger detent and using a dry
cotton bud clean the detent and it’s location point in
the Ego9 Body. (SEE FIGURE 9.4) Replace the detent back
into the Ego9 body (SEE FIGURE 9.5) and place the BBSS
back into the designated slot in the body (SEE FIGURE
9.2). Ensure that the sensor is face down in the body i.e.
looking into the breech.
Replace the Sensor Cover and using a 5/64" hex key,
replace the Bream Beam Sensor Cover retaining screw
to hold the sensor cover in place (SEE FIGURE 9.6).
Repeat the procedure for the opposite side of the Ego9.
You have now cleaned your Break Beam Sensor System.
CLEANING THE BREAK BEAM
SENSOR SYSTEM
Undo the retaining screw for the Break Beam Sensor
Cover on the right hand side of the Ego9 using a 5/64"
(2mm) hex key (SEE FIGURE 9.1).
Remove the Sensor Cover to expose the back of the Break
Beam Sensor unit (SEE FIGURE 9.2). Using a dry cotton
bud, carefully remove any debris, paint or moisture from
the back of the sensor unit and from inside the Sensor
Cover.
Lift the BBSS free from the Ego9 body and using
another dry cotton bud, remove any grease or debris
build-up from the front of the sensor unit (SEE FIGURE
9.3).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
NOTE: WHEN CLEANING THE BREAK BEAM SENSOR SYSTEM
INSPECT THE CONDITION OF RUBBER FINGER DETENTS
AND REPLACE IF NECESSARY. ENSURE THAT THE RECEIVER
SENSOR (INDICATED BY A RED MARK & RED HEAT SHRINK) IS
LOCATED ON THE RIGHT-HAND SIDE OF THE MARKER BODY.
FIG 9.6
FIG 9.5FIG 9.2
FIG 9.1
FIG 9.3
FIG 9.4
54.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
55.
MAINTENANCE
MAINTENANCE
QUICK GUIDE