Manual

REMOVING THE VALVE
ASSEMBLY
Lift the bolt pin and slide the bolt out of the rear of the
marker. Disconnect any hosing and unscrew the Inline
Regulator from the front regulator mount as detailed
in the “Cleaning the Inline Regulator” section of this
Maintenance guide (page 56-57). Remove the frame as
detailed on page 63.
Take the Ego9 body and turn it so that the underside
of the Solenoid Assembly, and Valve plug are visible
and accessible (SEE FIGURE 17.1). Using a 1/8” hex key
remove the screw from the front regulator mount that
holds the LPR Body into the marker body (SEE FIGURE
17.2).
Remove the entire LPR assembly, the valve spring and
the exhaust valve from the marker body (SEE FIGURE
17.3). Using a 1/8” hex key remove the valve plug from
the underside of the Ego9 body (SEE FIGURE 17.4). The
bottom of the exhaust valve guide should now be
visible through the valve plug hole (SEE FIGURE 17.5).
Ensure that the rammer is in its rear position and taking
an L-shaped hex key, place it down through the bolt
slot in the top of the body so that you can apply light
pressure to pop the valve guide out of its place in the
Ego9 body (SEE FIGURE 17.6).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
(CONTINUED)
Using a 5/64” hex key remove the Spool Cap and Spring
(SEE FIGURE 16.7). Remove the Spool Shaft using a pair
of needle-nosed pliers as shown in SEE FIGURE 16.8.
Clean the Spool Shaft using a cloth to wipe off any
paint, debris or old grease and lubricate all of the
o-rings on the Spool Shaft with Eclipse Grease before
re-inserting it (SEE FIGURE 16.9). Replace the Spool
Spring then Spool Cap using a 5/64” hex key to secure
them in place (SEE FIGURE 16.10).
Hold the Solenoid Assembly onto the bottom of the
Ego9 body, taking care to line it up correctly with the
screw holes in the body and to avoid pinching the BBSS
wires underneath it. Use a 5/64” hex key to tighten the
two screws that hold the Solenoid Assembly onto the
Ego9 body (SEE FIGURE 16.11).
You have now successfully stripped and cleaned your
Ego9 Solenoid Assembly.
FIG 17.3 FIG 17.4
FIG 17.2
FIG 17.5 FIG 17.6
FIG 17.1
FIG 16.10
FIG 16.11
FIG 16.8
FIG 16.7
FIG 16.9
68.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
69.
MAINTENANCE
MAINTENANCE
QUICK GUIDE