User's Manual

SWITCHING ON THE EGO10

To switch on the Ego10 press the button twice in quick

succession, referred to elsewhere in this manual as ‘double-

clicking’. The Ego10 can also be switched on by pushing

and holding the button FIGURE 3.1.

SWITCHING OFF THE

EGO10

Press and hold the button until the display shows TURN

OFF.

Release the button and re-press it to turn o the

Ego10. Alternatively double click the button to enter the

menu tree then press to turn o the Ego10.

FIRING THE EGO10

Pull the trigger to re the Ego10. The entire ring sequence

is controlled electronically by the Ego10 circuit board,

enabling any user to easily achieve high rates of re.

THE EGO10 CIRCUIT

BOARD

There are three sockets on the Ego10 circuit board two

of which are occupied by the BBSS connector (A) and

the Ego10 solenoid connector (B). The third socket on

the board (C) is the auxiliary socket to which third party

products such as loaders and RF transmitters can be

connected using the relevant wiring harness SEE FIGURE

3.2.

NOTE: THE AUXILIARY SOCKET IS TURNED ON AND

OFF MANUALLY VIA THE AUX OUT PARAMETER IN THE

HARDWARE MENU ON PAGE 44

NOTE: THE DOUBLE CLICKING FEATURE IS USER

SELECTABLE, FACTORY DEFAULT IS SET TO ON. IT CAN BE

TURNED OFF USING THE DOUBLE CLICK PARAMETER IN

THE HARDWARE MENU SEE PAGE 44

FIG 3.2

FIG 3.1

16.

QUICK SET-UP