User's Manual
FIRE MODE
THE FIRING MODE PARAMETER
This parameter is used to select the ring
mode of the Ego10 and has the following
choices:
> SEMI:
This is the default and in this ring
mode the Ego10 will re one shot for every
trigger pull.
> RAMP**:
In this ring mode, the rate of re is increased
above the rate at which the trigger is pulled once certain
criteria have been met. These criteria are set by the
parameters on the RAMP SETUP menu.
> CANCEL:
Editing is cancelled and the parameter is
unchanged.
ROF CAP
THE RATE OF FIRE CAP PARAMETER
The ROF CAP parameter is used to specify
whether or not the Ego10 should have a
limited, or capped rate of re. When the ROF
CAP
is enabled, the maximum achievable
rate of re is set by the BS ON ROF parameter.
Choices for the ROF CAP parameter are:
> OFF:
Rate of re only limited by the loader.
> ON:
Rate of re limited to the BS ON ROF
parameter value.
> CANCEL:
Cancel editing and leave the parameter
unchanged.
BS ON ROF
THE MAXIMUM RATE OF FIRE
PARAMETER
The BS ON ROF parameter is used to set the
maximum achievable rate of re from the
Ego10. The value of this parameter can be
adjusted between 4.0 and 30.0 balls per
second in 0.1bps increments.
The
BS ON ROF parameter will only be
displayed if you have set the ROF CAP
parameter to ‘ON’.
BS OFF ROF
THE RATE OF FIRE WHEN BBSS IS OFF
PARAMETER
The BS OFF ROF parameter is used to control
how fast the Ego10 cycles when the Break
Beam Sensor System is disabled. This
parameter can be set between 4.0 and 15.0
balls per second and should always be set
to the slowest speed of the loading system
in use.
NOTE: ALWAYS CALIBRATE YOUR EGO10 ROF CAP
PARAMETERS TO THE LOCAL FIELD BPS METER AS
READINGS MAY VARY FROM METER TO METER.
** NOTE: SOME PRESETS AND FIRE MODES MAY ONLY
BE AVAILABLE IN CERTAIN COUNTRIES AND ON SOME
MODELS OF THE EGO10.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO10
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
37.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE