User's Manual

SETTING UP YOUR EGO11
Before you can begin to use your Ego11, you will need
to attach an air system and a paintball loader.
INSTALLING A PRESET AIR
SYSTEM
Every Ego11 comes complete with a new Eclipse
Push Operated Purge System (POPS) which provides
a direct connection for a preset air system. Before
screwing an air system into the POPS ensure that
the Bonnet is disengaged in its forward position
(SEE
FIGURE 7A)
. If the Bonnet is engaged, depress the
Latch Button and slide the Bonnet forward.
Screw the preset air system into the POPS
(SEE
FIGURE 7B)
so that the bottle screws in all the way and
is tight. Pull the Bonnet backwards allowing the POPS
Pin to depress the pin in the preset air system causing
the Ego11 to become pressurised (providing that there
is sufficient air in your tank)
(SEE FIGURE 7C). When
the Bonnet has been pulled back far enough it engages
with the POPS Body.
1,2
You have now installed a preset air system onto your
Ego11.
1
High, mid and low pressure output preset air systems can be used
with the Ego11, providing the Ego11 has the SL3 Inline Regulator
originally supplied with the marker.
2
The force needed to engage the Bonnet may vary depending on the
output pressure and internal design of the air system being used.
THE EGO11 CANNOT BE USED WITH CO2. ONLY
USE COMPRESSED AIR OR NITROGEN.
FIG 7A
FIG 7B
FIG 7C
ALWAYS RELIEVE ALL RESIDUAL GAS PRESSURE
FROM THE EGO11 BEFORE UNSCREWING THE
PRESET AIR SYSTEM.
MAKE SURE THE MARKER IS TURNED OFF AND
THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING AN AIR SYSTEM.
18.
USING THE EGO11