User's Manual

(CONTINUED)

The Micro-switch Activation Screw is used to adjust

the point in the trigger pull at which the Micro-switch

is activated. Turn the screw clockwise to decrease the

amount of Trigger travel to the activation point. Turn

the screw counter clockwise to increase the amount of

Trigger travel to the activation point

(SEE FIGURE 10D).

The Spring Return Strength Screw is used to adjust

the spring strength that returns the Trigger to its

resting position. Turn the screw clockwise to increase

the amount of spring return strength in the trigger

pull. Turn this screw counter clockwise to reduce the

amount of spring return strength in the trigger pull.

Do not turn the screw too far counter clockwise or

there will not be enough force to return the Trigger

consistently

(SEE FIGURE 10E).

When setting the Trigger it is important to ensure that

the electronic trigger detection is working correctly.

When the Trigger is fully depressed the Trigger

Detection Indicator (TDI) should point upwards

When the Trigger is fully released the TDI should point

downwards .

For more information, see understanding the Trigger

Detection Indicator (TDI) on page 27 and The FILTER

menu on pages 41-43.

FIGURE 10F KEY

Spring

Spring Return Strength Screw

Trigger Pin Retaining Screw

Front Stop Trigger Screw

Magnet Return Strength Screw

Micro Switch Activation Screw

Rear Stop Trigger Screw

FIG 10D

FIG 10E

FIG 10F

22.

USING THE EGO11