User's Manual

THE LOW PRESSURE
REGULATOR (LPR)
1
The Inline Regulator can be removed if needs be.
Unscrew the LPR Cap from the marker body
SEE FIGURE 18A.
Remove the LPR Piston and Rear Spring from the LPR
Cap
SEE FIGURE 18B.
Cupping the palm of one hand, turn the LPR Cap
upside down and tip the Front Spring out into your
palm
SEE FIGURE 18C.
Remove the Rear Spring from the LPR Piston and
using a dry cotton bud, carefully clean the 013 NBR70
o-ring on the LPR Piston
SEE FIGURE 18D. If the seal
is damaged then replace it. Once the seal has been
cleaned, lubricate with a light application of Eclipse
Grease so that it is ready for re-assembly.
2
1
The internals of your LPR may vary according to the model of Ego11
you have.
2
The adjuster screw does not need to be removed from the LPR Cap
for regular maintenance.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 18A
FIG 18B
FIG 18D
FIG 18C
54.
MAINTENANCE