User's Manual

REMOVING THE FRAME
Disconnect any hosing and unscrew the Inline
Regulator from the Front Regulator Mount as detailed
in the SL3 Inline Regulator section of this maintenance
guide (pages 50-51).
Using a 5/64” hex key remove the four screws that
attach the Ego11 Rubber Grips to the Ego11 Grip
Frame
(SEE FIGURE 20A). Unplug the Solenoid and
BBSS wires from their sockets on the Ego11 Circuit
Board
(SEE FIGURE 20B).
Using a 1/8” hex key undo the two Frames screws
(SEE
FIGURES 20C & 20D)
and remove the Frame from the
Ego11 Body, taking care not to damage any wires
(SEE
FIGURE 20E)
.
You have now removed the Frame.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 20A
FIG 20B
FIG 20D
FIG 20E
FIG 20C
58.
MAINTENANCE