User's Manual

(CONTINUED)
Check the bottom face of the Solenoid Manifold to
ensure that it is also free from damage or debris
(SEE
FIGURE 22G)
. Remove, clean and inspect the Solenoid
Rubber Gasket as shown in
FIGURE 22H. Replace the
gasket ensuring that it lies flat in its designated groove
in the Solenoid Manifold Body
(SEE FIGURE 22G).
1
Inspect and clean the Solenoid Valve, removing any
moisture, dirt and debris, paying particular attention
to the top sealing surface and exhaust ports
(SEE
FIGURE 22I)
.
DO NOT ATTEMPT TO DISASSEMBLE THE SOLENOID
VALVE UNIT OR THE USER WARRANTY WILL BE
VOID.
Hold the Solenoid Manifold onto the bottom of the
Ego11 Body taking care to line it up correctly with
the screw holes in the body and to avoid pinching
the BBSS wires underneath it. Use a 5/64” hex key
to tighten the three screws that hold the Solenoid
Manifold onto the Ego11 Body
(SEE FIGURE 22J).
1
Hold the Solenoid Valve onto the bottom face of the
Solenoid Manifold ensuring the small Solenoid Rubber
Gasket is still in place, lining up the two screw holes
screw the Solenoid retaining screws into the Solenoid
Manifold
(SEE FIGURE 22K).
2
You have now successfully stripped and cleaned your
Ego11 Solenoid Assembly.
1
Replace any worn/damaged seals using authentic Eclipse Ego11
spare parts.
2
DO NOT over tighten retaining screws, doing so may strip the
threads or damage the part being retained.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 22G FIG 22H
FIG 22J
FIG 22K
FIG 22I
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
63.
MAINTENANCE
MAINTENANCE
QUICK GUIDE