Manual

Every Ego LV1 comes complete with an Eclipse Shaft4 barrel

(see page 72). The bore size of the Shaft4 barrel back is

engraved on the barrel back just in front of the body threads.

To install the Shaft4 barrel, firstly screw the barrel tip and

barrel back sections together. The threads on the Shaft4

barrel tip are REVERSE THREADED. To screw the two sections

together, with the barrel pointing away from you, turn the

barrel tip in a clockwise direction

(SEE FIGURE 6A)

While pointing the Ego LV1 marker in a safe direction, insert

the assembled Shaft4 barrel into the front of the Ego LV1

body and screw the Shaft4 barrel into the Ego LV1 (in a

counter-clockwise direction). Continue to screw the Shaft4

barrel into the Ego LV1 body until the barrel becomes snug in

the body

(SEE FIGURE 6B)

DO NOT

over tighten the barrel.

Install a barrel blocking device over the barrel such as the

Eclipse barrel sock supplied with the Ego LV1

(SEE FIGURE

6C)

. You have now installed the barrel.

Instruction on using the Eclipse Barrel Sock can be found on the Eclipse Barrel

Sock warning label.

The Eclipse Barrel Sock that comes with the Ego LV1 may differ from that

pictured in this manual.

iNSTALLiNG A BARREL

MAKE SURE THE MARKER IS TURNED OFF AND THAT NO

PAINTBALLS ARE IN THE MARKER OR LOADER BEFORE

INSTALLING A BARREL.

WARNING

FIG 6A

FIG 6B

FIG 6C

USiNG THE EGO LV1 11