Manual

THE PUSH ON PURGE
SYSTEM
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG 28A
FIG 28C
FIG 28E
FIG 28G
FIG 28B
FIG 28D
FIG 28F
FIG 28H
THERE IS NO NEED TO REMOVE THE POPS FROM THE EGO
LV1 FRAME FOR GENERAL MAINTENANCE. IF THE POPS IS
REMOVED, ENSURE THE O-RING IS CORRECTLY SEATED
BEFORE POPS RE-ATTACHMENT.
Fully depress the latch button then slide the bonnet forward
while continuing to depress latch button (SEE FIGURE 28A) .
When the bonnet is in the forward position (SEE FIGURE 28B)
remove the latch button and spring from the bonnet (SEE
FIGURE 28C) then slide the bonnet off the POPS body (SEE
FIGURE 28D) . Be careful not to lose the spring.
Carefully slide the push rod out from either side of the POPS
body, taking care not to lose the two o-rings on the push rod
(SEE FIGURE 28E) .
Clean off any dirt, debris or moisture from the bonnet, the
POPS body and the latch button (SEE FIGURE 28F) .
Remove the POPS insert assembly using a 5/32” hex key (SEE
FIGURE 28G) . Remove the POPS pin from the POPS Insert.
Clean and check the condition of the 007 NBR70 o-ring on
the outside of the POPS insert, replacing as necessary (SEE
FIGURE 28H) .
62 MAiNTENANCE