Manual

(CONTiNUED)
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
FIG 28I
FIG 28K
FIG 28M
FIG 28O
FIG 28J
FIG 28L
FIG 28N
FIG 28P
Clean and check the condition of the single internal
005 NBR90 o-ring in the front of the POPS insert, replace if
necessary (SEE FIGURE 28I) . Lubricate this o-ring liberally using
Eclipse grease.
Lubricate the narrow end of the POPS pin with a smear of
Eclipse grease and push the pin, narrow end first, into the POPS
insert so that it sits in the POPS insert and pokes through to
the front (SEE FIGURES 28J & 28K) .
Screw the POPS insert back into the POPS body ensuring that
the o-ring end goes in first (SEE FIGURE 28G) .
Replace the push rod into its designated slot (SEE FIGURE
28L) , then side a 004 NBR70 o-rings on both ends of the push
rod. Make sure the push rod is centred in the POPS body (SEE
FIGURE 28M) .
Slide the bonnet over the POPS body and align the hole on the
bonnet with the front hole on the POPS body (SEE FIGURE 28N) .
Ensure the spring is on the latch button then slide them both
into the POPS body through the hole in the bonnet, spring end
first, making sure the latch button pokes out the right side of
the bonnet ( SEE FIGURE 28O) .
Push the button down as far as it will go, then (while still
holding down the button) slide the bonnet back until the button
engages with the POPS body and cannot slide into the forward
position (SEE FIGURE 28P) .
You have now successfully cleaned and maintained the Push On
Purge System.
MAiNTENANCE 63