Manual

This parameter is used to select the firing mode of the Ego LV1 and has the following choices:
> SEMI: This is the default and in this firing mode the Ego LV1 will fire one shot for every trigger pull.
> RAMP: In this firing mode, the rate of fire is increased above the rate at which the trigger is pulled once certain
criteria have been met. These criteria are set by the parameters on the RAMP SETUP menu.
1
> CANCEL: Editing is cancelled and the parameter is unchanged.
The ROF CAP parameter is used to specify whether or not the Ego LV1 should have a limited / capped rate of fire.
When the ROF CAP is enabled (and the BBSS is enabled), the maximum achievable rate of fire is set by the BS ON
ROF parameter. Choices for the ROF CAP parameter are:
> OFF: Rate of fire only limited by the loader.
> ON: Rate of fire limited to the BS ON ROF parameter value.
> CANCEL: Cancel editing and leave the parameter unchanged.
1
Some presets and fire modes may only be available in certain countries and on some models of the Ego LV1.
FiRE MODE PARAMETER
ROF CAP PARAMETER
The BS ON ROF parameter is used to set the maximum achievable rate of fire from the Ego LV1. The value of this
parameter can be adjusted between 4.0 and 30.0 balls per second in 0.1bps increments.
The BS ON ROF parameter will only be displayed if you have set the ROF CAP parameter to ‘ON’.
BS ON ROF PARAMETER*
The BS OFF ROF parameter is used to control how fast the Ego LV1 cycles when the Break Beam Sensor System is
disabled. This parameter can be set between 4.0 and 15.0 balls per second and should always be set to the slowest
speed of the loading system in use.
BS OFF ROF PARAMETER
30 ADVANCED SETUP