Manual

Remove the rubber Detent and using a dry cotton bud
clean the Detent and its location point in the Ego LV1 body,
replacing the Detent if it is damaged (SEE FIGURE 15D) .
Reinsert the Detent back into the Ego LV1 body and place
the BBSS back into the designated slot in the body to re-
assemble FIGURE 15B. Ensure that the sensor is face down in
the body i.e. looking into the breech.
1
Check that the cam carrier screws are still tight in the body.
DO NOT over tighten the screws on the body or cam carrier
may be damaged (LABELLED
A
FIGURE 15E) .
Before replacing the eye cover ensure the wire is flat in the
pocket in the LV1 body and does not lie over the cam carrier
or retaining screws. This will prevent the wires being crushed
by the eye cover (LABELLED
B
FIGURE 15E) .
Replace the eye cover and using a 5/64" hex key, replace the
eye cover retaining screw to hold the eye cover in place (SEE
FIGURE 15F).
Repeat the procedure for the opposite side of the Ego LV1.
You have now cleaned the BBSS.
1
Ensure that the receiver device (indicated by a red mark & red heat shrink) is
located on the right-hand side of the marker body.
(CONTiNUED)
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
A
A
B
FIG 15D
FIG 15E
FIG 15F
MAiNTENANCE 43