Manual

THE CURE5 BOLT ASSEMBLY
Raise the bolt pin and remove the bolt assembly from the Ego
LV1 marker body (FIGURE 18A) .
Using a dry cotton bud remove any paint or grease from the surface
of the bolt.
Lubricate the two bolt o-rings (LABELLED
A
FIGURE 18B) with
a small drop of oil (SEE FIGURE 18C)
1
. Remove any excess
oil from the surface of the bolt before re-installing the bolt
assembly. Over-lubrication of the bolt may have adverse
effects on performance.
Clean and inspect the rubber bolt tip
A
and Detent slots
B
on the bolt . If the bolt tip is heavily worn or damaged then
remove and replace (FIGURE 18C) . Lubricate the bolt tip with
a few small drops of oil around the circumference of the bolt
tip.
Replace the bolt assembly checking that the bolt is free to
move and moves smoothly back and forth in the LV1 body. If
there is any resistance or friction in the bolt movement then
replace the two 14x2 o-rings and the rubber bolt tip.
Lock the bolt pin into the designated slot in the rammer using
the front o-ring on the bolt as a position reference guide
(LABELLED
A
FIGURE 18D) .
INCORRECT LOCATION OF THE BOLT CAN SERIOUSLY DAMAGE
THE BODY OF YOUR EGO LV1.
1
We recommend the use of Eclipse Oil on the Ego LV1 rammer and bolt.
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
A
A
B
A
A
FIG 18A
FIG 18B
FIG 18C
FIG 18D
MAiNTENANCE 47