Manual

THE ZiCK3 RAMMER
ASSEMBLY
Pull the bolt pin upwards so that it disengages the rammer
assembly, allowing the bolt to be removed via the rear of the
Ego LV1 (SEE FIGURE 19B) .
Using a 3/16" hex key, unscrew and remove the rammer cap
at the rear of the Ego LV1 (SEE FIGURE 19C) .
Raise the front of the Ego LV1 and tap the Ego LV1 onto
your hand until the rammer falls into the palm of your hand
(SEE FIGURE 19D) .
Thoroughly clean the rammer shaft and all of its o-rings,
replacing any o-rings which appear damaged or worn
(LABELLED
A
FIGURE 19E) . Lubricate all of the seals on the
rammer shaft using Eclipse gun oil, do not use grease on the
rammer as this may cause adverse performance effects.
Replace any worn seals/bumpers using authentic Eclipse Ego LV1 spare parts.
DO NOT use Eclipse Grease on the rammer. Only use light paintgun oil, we
recommend Eclipse Oil.
The number of o-rings on the rammer may vary according to the model of Ego
LV1 that you have.
Included with the Ego LV1 is a lightweight Zick3 rammer
(LABELLED
A
FIGURE 19A) , in addition to the standard Zick3
rammer installed in the marker (LABELLED
B
FIGURE 19A) .
The lightweight Zick3 rammer will provide an increase in
shot efficiency at the cost of requiring a slightly higher valve
operating pressure.
To install the lightweight Zick3 rammer follow the maintenance
procedure below, swapping over to the lightweight rammer.
After installation, re-chronograph the Ego LV1 and adjust the
SL4 inline regulator accordingly.
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
A
A
B
A
A
A
FIG 19A
FIG 19B
FIG 19C
FIG 19D FIG 19E
ALWAYS CHECK THE SHOOTING VELOCITY OF THE EGO LV1 WITH A
CHRONOGRAPH BEFORE USING THE MARKER.
48 MAiNTENANCE