Manual

THE TRiGGER ASSEMBLY
Having removed the frame completely from the Ego LV1 body
(see page 52). Unscrew the two M2.5x5 retaining screws which
hold the bearing carrier in the frame (SEE FIGURE 24A) .
Gently lift the bearing carrier and trigger assembly free from
the frame taking care not to damage the micro-switch or the
OPTO sensors (SEE FIGURE 24B) .
Remove the trigger spring from the bearing carrier, removing
any paint or moisture (SEE FIGURE 24C) .
Using a 1/16” hex key, loosen the trigger pin retaining set
screw from the back of the trigger (SEE FIGURE 24D) .
Use a small hex key to push the trigger pin out of the
bearing carrier from one side (SEE FIGURE 24E) , then remove
the bearing carrier from the trigger (SEE FIGURE 24F) .
Clean the trigger and bearing carrier thoroughly and also
clean the space within the frame that the trigger sits in.
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG 24A
FIG 24C
FIG 24E
FIG 24B
FIG 24D
FIG 24F
54 MAiNTENANCE